Shaft coupling60 viewsThis is a machined cone compression coupling
|
|
Cone49 viewsHere you can see the cone shape
|
|
Key48 viewsNote the machined slot for the key and the indexing mark
|
|
Motor shaft key51 viewsHere you can see the key installed on the motor shaft. It is a snug fit.
|
|
Another view46 viewsTry installing the key in several way to get the best fit. It should be snug but not binding and slide with finger pressure.
|
|
Close up48 viewsNote the slight tarnish on the cone. This had caused it to stick. I backed out the bolts and taped it with a mallet to loosen the two pieces, clean it with some fine steel wool and then installed it on the motor shaft.
|
|
Coupling mounted44 viewsHere the coupling has been fitted and snugged down, but not tightened. The flywheel goes on next to trial fit and get the depth correct before tightening the coupling down.
|
|
Trial fit54 viewsDry fitting the adaptor ring before running out and buying some new hardware.
|
|
Another shot62 views
|
|
|
|
|
|
|
