29 viewsI used some Permatex Solvo Rust on all the bolts and nuts. I have had this can for over 30 years and I got it from my father. So, there is no telling how old this stuff is, but it works better than anything I have ever used.
|
|
26 views7mm box end for the bleeder valve.
|
|
24 viewsIt comes out without a problem.
|
|
30 viewsA torx and a 11mm 6 point socket. I used a cheap socket that I ground down the face to get maximum contact on the outer nuts that you can't get all the way down on.
|
|
30 viewsAll the bolts an nuts came out without a problem.
|
|
39 viewsHalves split
|
|
32 viewsAdjuster cap
|
|
34 viewsRemoving the cap reveals the piston adjuster.
|
|
31 viewsI removed the retaing ring and the old dust boot.
|
|
32 viewsTurning with a 4mm allen pushes the piston most of the way out.
|
|
35 viewsI rocked it back and forth by hand to get the piston the rest of the way out.
|
|
38 viewsA dental pick comes in handy to remove the inner seal.
|
|
|
|
